frjeff
New member
Soon to begin putting kit together (drum being sandblasted today).
On the bottom vents: has everyone found them to be a good tight fit (little air escaping in when slider is closed)?
I had a dream last night that mine were letting in way too much air when closed and that I could not get temps down. So, perhaps I ought to place a bit of high temp sealant between the vent and drum.
Any basis to this idea or was it simply a nightmare?
On the bottom vents: has everyone found them to be a good tight fit (little air escaping in when slider is closed)?
I had a dream last night that mine were letting in way too much air when closed and that I could not get temps down. So, perhaps I ought to place a bit of high temp sealant between the vent and drum.
Any basis to this idea or was it simply a nightmare?